Fire protection department is responsible for the

  • Detail

It is reported that a number of national standards related to fire retardant coatings are being formulated or revised, one of which is to increase the requirements for on-site testing of the performance of fire retardant coatings, and give the corresponding testing methods and standards. This will provide the basis and method for the fire department to scientifically supervise the use of fire retardant coatings

it is understood that China's building regulations stipulate that the fire department is responsible for the acceptance of the performance of building fire retardant coatings. However, due to the lack of on-site testing standards and operational methods, it has been difficult to test the performance of fire retardant coatings. The first draft of a new standard "code for fire protection technology of building steel structures including 129 kinds of new materials" has been completed and comments are being solicited. At the same time, the revised version of the national standard "code for design of steel structures" is also being formulated. These two standards will require the fire department to conduct on-site inspection on the performance of the fire-proof coating used in the acceptance of buildings to determine whether the fire-proof coating used meets the design requirements

powerful fire retardant coating enterprises at home and abroad generally welcome the formulation and revision of these standards. The person in charge of a number of fire retardant coating production enterprises from Beijing, Jiangsu and Sichuan said that this will help put the supervision of the use of fire retardant coating on the agenda, greatly change the current market chaos caused by the lack of supervision, and make some inferior enterprises unable to survive

note: the reprinted content is indicated with the source. The reprint is for the purpose of transmitting more information, and does not mean that it agrees with its view or proof, and can cause oscillation or pipeline leakage. The true A-type fixture 1 is generally applicable to the pipe diameter φ The plastic pipe property below 630

Copyright © 2011 JIN SHI